ISONEM PAINT AND INSULATION TECHNOLOGIES

ANTI MOISTURE PAINT, It is a very strong synthetic insulation paint which has been modied by special chemicals and polymers to eliminate the moisture and dampness problems in the interior and exterior walls of
the buildings because of natural conditions. It can be applied to any kind of humid or dry walls, painted and unpainted surfaces. Thanks to its excellent alkali and moisture resistance, it prevents the formation of moisture
on the walls and destroys if there is any. The adhesion strength in all kinds of surfaces is extremely strong, does not swell, high chemical resistance, it is not aected by UV, rain, water or salt. It is used in interior and exterior
walls, in basements, in garages or in cellars, in interior walls facing north and in humid areas. It forms a lm layer showing excellent moisture resistance on the surface applied. Even if the paint or wall is humid, it adheres
very well to the surface. It is not aected by salt water and eorescence. Thanks to this feature, it is also used to solve the problem of paint swelling in buildings. While ISONEM MS 82 penetrates into the walls and dries
up the humidity inside the walls with the special chemicals in its ingredients. ISONEM MS 82 paints do not cause any side eects on the applied surface.
USAGE AREAS
· On moist walls, on painted or non-painted waIls aected by humidity
· On the interior and exterior walls of the foundation
· On the walls of the basement oor
· On surfaces and oors coated with plaster, concrete, alum, etc
· In tunnels, on the walls of buildings facing north
· In the elimination of problems arising from humidity and moisture.
APPLICATION INFORMATION
Surface preparation : ISONEM MS 82 anti moisture paint is ready to use, no primer is required. Formation in black color that occurred on walls must be cleaned before application. The application surface may be humid,
damp or dry. It can be applied to painted or unpainted all surfaces. If there are swelling parts on the painted surfaces, the application surfaces should be cleaned and a tough surface should be obtained by using
appropriate repair mortar.
Application method : Open the ISONEM MS 82 cover from its original package and mix thoroughly for 3 minutes. After the mixing process, it is recommended to apply with a brush, suitable sprayer or especially
synthetic epoxy roller without diluting the product to the existing surface. Apply one coat and wait for 24 hours and apply the second coat. The application areas should be ventilated well and also mask, gloves and
protective glasses should be used during application.